网投平台., LTD.

Acrylic Rewan molding

2016-08-22 16:02:42

网投平台After bending acrylic products will be more gentle, more varied shapes, widely loved by the people, so many in the production of acrylic products are needed after bending process. In the bending process, depending on the shape of the different needs, divided into two partial bending and bending whole. Overall bending process is the acrylic plate all melt, this step is needed into the oven. In this process needs to be required after molding of acrylic products and molds stacked together inside the oven, the oven when the temperature was raised to the melting point of acrylic, acrylic plate will gradually soften, and finally completely docile in the mold. It should be noted that time is also a need to control the temperature of the oven can not be a one-time rise too high in acrylic and bonded abrasive later, you can take it out the oven to cool molding process. Acrylic hot melt back after the encounter cold air gradually harden and begin to fixed shape.

Bending locally bending process acrylic products is relatively common one. The most common is the straight acrylic bending out an arc, like a circle, arc, and so on. There are also some more trouble bending locally, such as an acrylic bending at a right angle, but at a smooth arc bending. This process is in addition to torn this bending acrylic board pasted stickers, with a high temperature mold bar will require bending acrylic hot melt edge, then use force bent at right angles to it. Out of acrylic products such smooth curved edge is a right angle.


Friendship link : | | | | | | | | | | | |